Best Info About How To Start Inetd In Solaris 10

Enabling telnet on solaris 10. Use the service management facility (smf) to modify the. Adding new service (s) to /etc/inetd.conf.

how to reduce sensitivity how to keep your gas bill low how to quit your part time job how to live with a virgo how to reduce muscle recovery time how to learn linux server how to improve morale at work how to keep honey liquid

2

Chapter 16 Introduction To Solaris Zones (System Administration Guide: Oracle Solaris Containers-Resource Management And Oracle Solaris Zones)

Chapter 16 Introduction To Solaris Zones (system Administration Guide: Oracle Containers-resource Management And Zones)

How To Restart Inetd Service In Linux - Kernel Talks

2

Solaris 10 Workshop Service Management Facility

After performing all of the following:

How to start inetd in solaris 10. These 4 dependents have their own dependents not. Adding new port number (s) and name (s) to /etc/services. Inetd on this solaris 10 zone fails to start at boot time.

Login back into the system and enable telnet using svcadm. Hi, here is the questions: The inetd daemon starts at boot time using the /etc/rc2.d/s72inetsvc script.

May 4, 2009 by gleb reys 3 comments. A configuration file lists the services that the inetd daemon will listen for and start in response to. Both environments are solaris 10 i set my env up like this:

To list the dependencies of the inetd service, use the svcs. Inetadm command is used for observing and managing inetd services in solaris 10. The inetd daemon starts up internet standard services when a system boots, and can restart a service while a system is running.

If you run this command without. Solaris 10, start inetd in a zone not working. Inetd has 4 dependents not started.

Is there a way to find. Now take a look at the list of services on which inetd depends. To enable or disable inetd refer to svcadm(1m) on how to enable.